| |
Installation |
|
Now, Position the Binding on top of the AutoSpin2
Make sure that the binding, is oriented, with the toe end pointing, directly toward the front of the snowboard.
This is done to assure that the Skating stance is established facing directly ahead, since the Ride Stance Angle, can easily be adjusted later, in seconds.
Now position the Retainer Disk. Aligning it, so that all four threaded insert holes on the top of the AutoSpin2, will readily accept their screws. You may have to try different angles for best location, and slightly adjust the location of the binding.
Then insert the screws into the threaded holes, and screw them down. Finish the installation by making sure the screws are really tight so you are confident of a good safe installation.
|
