Installation

  
    In a Goofy installation, the Yellow Release Lever mounts  Left rear.
    The Instructions show the three steps for installing the unit on a 4-hole pattern board either Regular or Goofy. 
    Either way the unit must be oriented,  toward the front end of the snowboard. 
     Remove the AutoSpin2 from the protective rapper and set the screw packet aside.
     Position the AutoSpin2 over the 4-Holes on the board that you want to use for the installation,  making sure you can see them through the holes in the Autospin2.
     Notice, the Yellow Release lever must be positioned at the right rear, and the Label, with the RED ARROW, on the top of the AutoSpin2, should be pointing toward the front end of the snowboard.
     Get the screws out of the little baggy.  Insert them into the four holes that go all the way through the AutoSpin2 and screw them into the threaded inserts of the Snowboard, and screw the in one at a time
     Then use the power Philips to wrench the screws down tight.

Mounting AutoSpin2:

Select Step: -1-  -2-  -3-  -4-  3H

     Before mounting  AutoSpin2,  on the board, clean off the top of the snowboard,       
     Here we show the installation for a Regular Stance on a four hole pattern board. Note the Yellow Release lever is positioned right rear.